Servo Mount Bracket for RC10B7 Vehicles (JCO5161-2)

An aluminum servo mount bracket designed for RC10B7 racing cars, this lightweight brace secures the steering servo to the chassis for steadier, more consistent steering. Its wrap-around design helps spread the load across the mounting area, reducing flex during hard hits and helping maintain steering trim throughout a race.

The bracket fits inside the chassis servo mounting area with two mounting points and side set screws to precisely position and lock the servo in place. It provides extra clearance for servo leads on common high-torque servos and adds a clean, race-ready look to the setup. Installation is straightforward: remove the servo, position the brace, loosely reattach the original screws, center the servo between the brace, then install the side set screws and apply a light amount of thread-locking compound to secure before fully tightening. After installation, re-seat the servo and verify steering response and trim.